01/14/05

My Work

First photos are of a PU I did. next group are of a PEM. These are just a couple of the ones I have done to give you a idea of the quality of my work.

Bad Job

Bottom 3 photo's are of a rifle I had a customer send me to see if I could correct. Whoever did the work did a very bad job. To start with, the holes were not drilled true, you can see the back hole is higher than the front. They did not drill the holes for the pins. Then to hide that fact, they installed them in the mount and then just cut them off. The propper size tap is a 6mm X .75 thread. It is not a common size that you can just pick up at Home Depot or Sears. Since it appears they did not have the right they rand a die down the screws to make them into a thread to match the tap they did have. The stock cut out is also not well done.

So even if you do not have me do the work, be sure of who does do it.

Click on Photos to enlarge

PE, Repo Mount and Base	PE Mount	PE Mount
PEM Real mount and Base X Sniper	PEM Cut Out	PEM Bolt
Original X Sniper. Original Base Repo Mount	Close up of Cutout	Bolt Handle
K98 Swept Back Repo Mount	Stock Cut Out	Bolt Side
Bad Work They did not even drill the holes for the pins. Also the holes were not drilled straight.	Bad Work See the pins in the Mount?	Bad Work They simply cut them off.
Bad Work They did not have the proper Tap, so they just ran a a die on the screws to make the threads match a tap they did have	My Mark All Rifles I do will have a capital RR on the left side of the recoil lug.

 

 

This site was last updated 11/23/04